Welcome to the website of Foshan Nanhai GuDi door manufacturing Co., Ltd!

广东省 佛山市南海区固迪门业制造有限公司

Foshan Nanhai GuDi door manufacturing Co., Ltd

National Service Hotline

18664206785
当前位置:Home » 新闻中心 » 新闻标题

What are the installation methods for industrial doors?

Industrial doors are often used for doors and other industrial buildings for the passage of people or vehicles. Generally, the size and weight of the door are large and the safety requirements are higher. The following summarizes the installation method of the industrial door:


Upper slide type: This method refers to the method of the industrial door of the door leaf moving upward through the guide rail.

 

Sectional upturn: This method refers to the device method of an industrial door with a straight door fan passing up the rail and having a segmented steering motion.

 

Straight promotion: This method refers to the device method of the industrial door that the door leaf moves through the navigation straight up.

 

Layered straight promotion: This method refers to a device method in which several door fans are stacked one on top of the other and passed through the guide rail and the transmission system to make the industrial doors move up and down vertically.

 

Conventional device method: This method refers to a device method in which the horizontal rails of the left and right side devices are not required to adopt a special method, and the horizontal rails of the left and right devices are all capable of normal operation, and are mainly applied to the threshold height of not less than 600 mm. The hole.

 

High-level promotion: This method refers to the device method of the sectional-turning industrial door in which the door leaf runs straight through the guide rail and then segments and turns to move.

 

Overhead device method: This method refers to the device method of the straight-lifting industrial door on the top of the completely open door leaf of the torsion spring balance system.

 

Middle-mounted device method: This method refers to the device method of the straight-lifting industrial door in the center of the completely open door leaf of the torsion spring balance system.

 

Counterweight balancing method: This method refers to the device method of the straight-lifting industrial door that uses the weighting method to balance the door leaf component.

 

Push-pull type: This method refers to the device method of the industrial door that pushes and pulls the door leaf to the left and right direction through the guide rail and the transmission system.

 

Upper load-bearing type: This method refers to the device method of the push-pull industrial door that the door leaf component is accepted by the door top rail.

 

Lower load-bearing type: This method refers to the device method of the push-pull industrial door that the door leaf component is accepted by the ground rail at the lower part of the door leaf.

 

Lower load-bearing motor fixed method: This method refers to the device type of the lower load-bearing industrial door with a fixed orientation of the door opener.

 

Lower load-bearing motor follow-up method: This method refers to the device method of the lower load-bearing industrial door with the door opener device moving on the door leaf with the door leaf.


Consultation

phone

Service Hotline

18664206785

WeChat

二维码

Wechat scan

email

Email of Foshan Nanhai GuDi door manufacturing Co., Ltd

goodoorwin@hotmail.com